|
LUTRON CM-9941 SMART CLAMP METER
|
|
Description: SMART CLAMP METERModel : CM-9941* Smart operation, 3 intelligent function : A, V, Ohm.* V: ACV, DCV measurement automatically.* Ohm: Ohm, Diode, Continuity, Cap. automatically.* A: ACA (600A, 400A).'* Frequency measurement.* 4,000 counts, 30 mm conductor size.* Size : 178 x 64 x 33 mm. |
NEW PRODUCTS 2009
|
|
|
DKK-TOA BPM-2000
|
|
Designed for oil refinery
Automatic fractional distillate analyzer of batch distillation type enables distillation test of petroleum products such as kerosene, diesel oil, gasoline and etc.
Adopts high resolution liquid level detecting sensor
Newly-developed FA computer embedded with large-sized, color touch panel
Explosion-proof TIIS fd2G4 certified
Meas. range
Standard:Light gas oil (0 - 400 degrees C), Kerosene (0 - 300 degrees C), Gasoline (0 - 200degrees C)
|
Boiling Point Analyzer
|
|
|
YOKOGAWA SOURCE MEASURE UNIT GS610
|
|
The GS610 is a highly accurate and highly functional programmable voltage/current source that incorporates voltage/current generation and measurement functions. The maximum output voltage and current are 110 V and 3.2 A, respectively. Evaluation of over a wide range of basic electrical characteristics is possible, because the GS610 can operate as a current source or a current sink. |
SOURCE MEASURE UNITS
|
|
|
Sew ST-360TRn
|
|
FEATURES
● Easy to read 3-color scale...for mistake proof reading.● Mirror scale...makes reading pointer easy.● Fuse protection function.● Safety fused...on all ranges.● Diode protected meter...prevents damage due to overload.● hFE and db measurement.● With stand...makes reading and measuring easy.
SPECIFICATIONS
DC volts
0-0.1 / 0.5 / 2.5 / 10 / 50 / 250 /... |
Analogue Multimeters
|
|
|
TST0077-470 Germany-made Multifunction Tachometer
|
|
rpm measuring instrument set: Instrument with SoftCase (protective case) in transport case, incl. adapter, probe tip, surface speed disc, reflectors, batteries and calibration protocol |
From Germany
|
|
|
YOKOGAWA DL850E/DL850EV SCOPECORDER
|
|
Measure and analyze a wealth of signals in real-time and speed up development and fault finding.
The DL850E ScopeCorder is a powerful portable data acquisition recorder and oscilloscope that can capture and analyze both transient events and trends up to 200 days. Using flexible modular inputs it combines measurements of electrical signals, physical (sensors) and CAN / LIN serial buses and is able to trigger on electrical power related and other calculations in real-time.
Localized language... |
SCOPECORDERS
|
|
|
GW INSTEK GDS-1000A-U Series
|
|
Features
* 150/100/70MHz Bandwidths* 1GSa/s Real-Time Sample Rates Maximum, 25GSa/s Equivalent-Time* 2Mega Points Record Length* 2mV~10V Vertical Scale* 1ns~50s Horizontal Range* Up to 27 Automatic Measurements* 5.7" TFT LCD Display* USB Host and Device Interface Supported* Go/NoGo Function* Data Logger* Limited Lifetime Warranty |
Digital Oscilloscopes
|
|
|
3B5700
|
|
150°C ½ AA High Temperature Battery |
Data Logger Batteries
|
|
|
GW INSTEK GDS-1000-U Series
|
|
Features
* 100/70/50 MHz Bandwidth with 2 Input Channels* 250MSa/s Real-Time and 25GSa/s Equivalent-Time Sampling * 4k Memory Length per Channel * Peak Detect as Fast as 10ns * Save/Recall of 15 Front Panel Settings & Waveforms * 5.7" TFT Color Display * 19 Auto Measurements * Arithmetic Operators - Add, Subtract, FFT * USB Port for PC Connection* Data Logger * Limited Lifetime Warranty
|
Digital Oscilloscopes
|
|
|
CENTER TP-K01 K-Type general purpose bead probe
|
|
Features:
Measurement range: -50 to 200°C; -58 to 392°F
Tolerances: ±2.2°C (±3.9°F)
|
Thermal_Probes
|
|
|
Fluke 115/Fluke 116/Fluke 117 TRMS Digital Multimeter
|
|
Resistance, continuity, frequency, capacitance, and diode test
Measures 20 A (30 seconds momentary; 10 A continuous)
Large white LED backlight to work in poorly lit areas
Compact ergonomic design for one-handed operation
Compatible with optional magnetic hanger (ToolPak™)
True-rms for accurate measurements on non-linear loads
Min/Max/Average with elapsed time to record signal fluctuations
CAT III 600 V safety rated
|
Fluke
|
|
|
Kyoritsu 3321A
|
|
AC Voltmeter with linear, easy-to-read scales.
•
Auto discharge function; any charge stored in the circuit under test will be automatically discharged after testing.
•
Designed to meet IEC/EN 61010-1 CAT.III 600V, CAT.II 1000V
•
Color-coded scales for easy reading.
•
Back light function to facilitate working at dimly illuminated locations.
•
Test lead set with remote control switch.
•
Shoulder strap for hands free.
|
Analogue Insulation Tester
|
|
|
TMT114-CROSS HATCH CUTTER
|
|
Specifications
H cross hatch cutter is applicable to determine the adhesion of organic coatings by cross-hatching.
This instrument is designed for assessing the resistance of paint or related coatings to separation from substrates when a right-angle lattice oattern is cut into the coating, penetrating through to the substrate. The Cross Hatch Cutters conform with the requirements of :BS 3900 E6;BS/EN ISO 2409;ASTM D 3359;GB/T 9286, ,it is economy. Main Technical Parameters: 1.Six working... |
CROSS HATCH CUTTER
|
|
|
CIA038 Dial Fruit Sclerometer Fruit Ripeness Tester Meter Indicator
|
|
I.Introduction:
Fruit Sclerometer can measure the hardness of apples,pears,strawberries and grapes,etc.It is a suitable instrument for fruit company,fruit farm,fruit research institutions to test the ripeness of fruits,with compact size,low weight and ocular reading.It is suitable to use on the acene and also can be applied with its matched test stands to improve the accuracy.
II.Parameters:
Capacity: 2-15
Pressure Diameter: 3.5mm
Accuracy: +/-0.1
Pressure Depth:... |
Fruit Hardness Tester (Sclerometer)
|
|
|
PAL series digital Refractometer
|
|
Easy to see and be used. Big digital reading. Water resistant. |
Digital refractometers
|
|
|
Kyoritsu 5010 (for Current) / 5020 (for Current & Voltage)
|
|
3 channel inputs for the simultaneous recording of Leakage Current, Load Current and Voltage
•
Power Quality analysis(only on KEW 5020)(Power Quality:Reference voltage, Swell, Dip, Short power Interruptions)
Large Capacity for storing 60,000 data points
60,000 data points can be recorded when 1ch is used, and when all the three channels are used, 20,000 data points per channel can be recorded
Lowpass Filter will filter out the... |
Logger
|
|
|
Sew 165 CB
|
|
FEATURES
Multi-purpose Cable Tester
● 165 CB is an ideal tool which can test the correct pin configuration for different kinds of cables.● For testing: -RJ45/RJ11 -USB -COAX -BNC cable -Multi-wire cable● Auto-scan and manual-check function● Buzzer sound warning for wire status● 2 LED module indicators on the master unit which can do both of transmitter and receiver functions... |
Cable Tester and Cable Tracer
|
|
|
Sew ST-375
|
|
FEATURES
● Designed for measuring AC current, AC voltage resistance and DC voltage .● Rotary scale which presents only one scale in windows at one time to avoid any possible reading errors.● Pointer lock function freezes the reading in dimly lit or hard to reach places.● Ω range ideal for checking the continuity or relays, transformers and motor coils.
... |
Rotary Scale Clamp Meters
|
|
|
LUTRON RT-606 3 PHASE ROTATION TESTER
|
|
Description:
3 PHASE ROTATION TESTER Model : RT-606 * 3 phase rotation detector. * Input : 100 - 660 V AC. 45 to 70 Hz. * Power supply : None. * Structure : Electronic
|
3 phase rotation, motor testers
|
|
|
Sew 890 PR
|
|
FEATURES
● The 890 PR is a Non-Contact phase detector with flashing LEDs and a beeping buzzer to show the detection of AC 3-phase sequence.● Two functions in one unit : open phase and phase sequence detection.● Convenient brightness switch to make the indication visible in dim areas or sunlight.● Back cover magnet attaches the instrument to the AC distribution panel offer easy measurement.● 3-Phase... |
Non-Contact Type Phase Sequence Indicators
|
|